What do i need to hook up subs to a stock radio

what do i need to hook up subs to a stock radio

How do you hook up a subwoofer to an amp?

Connect the subwoofer to the amp with speaker wires if they are separate. Unspool enough speaker wire to extend from the amp to the subwoofer’s inputs. Then, strip 1⁄2 in (1. 3 cm) off both ends. Look for positive (+) and negative (-) terminals on both devices.

Can I add a subwoofer to my factory stereo?

Adding a subwoofer to your factory stereo is a great way to improve your sound without giving up your familiar factory controls. In this video, you can follow along as one of our experts installs an amplifier and subwoofer in a car with a factory stereo. Youll see all the basics of amplifier installation, including:

How do you wire a car stereo from the trunk?

Run the remote and RCA wires from the trunk to the stereo head. If you can, run these wires on the opposite side of the car from the power wire. Make use of any available space underneath the carpet or side panels. The remote wire is usually colored blue, while the RCA wire has of red and white plugs.

How to connect a car stereo remote to a subwoofer?

Connect the blue remote wire to the blue stereo wire. Your stereo will have a bunch of colored wires inserted into a black connector. The blue wire may be plugged into this connector or left loose. The easiest way to join this wire with the one you’re using for the subwoofers is with a plastic connector, like a crimp connector or Posi-connector.

How do I connect a subwoofer to an amplifier?

Connect the subwoofer output to the amplifier input. The jack on the amplifier may even be labeled subwoofer output, just to make things easy for you. Make sure both the subwoofer and the amplifier are turned off and disconnected from the power source. Youll then need to connect your amplifier to your speakers.

How do you connect a subwoofer to a RCA jack?

To convert speaker level outputs from your amplifier or receiver to RCA jack subwoofer outputs, you’ll connect the provided speaker wire connections (marked by colors and striped) just like you would regular speakers. You then connect RCA cables (or a single cable, depending on your particular one) to your powered subwoofer.

Does a powered subwoofer need an amplifier?

A powered subwoofer does not need an external amplifier; it has a built-in amp that supplies it with power. You will most likely connect it to the wall for its power source.

What cable do I need to hook up a subwoofer?

If your subwoofer has a single RCA subwoofer input jack, you may want to pick up a “Y” RCA adapter to combine both receiver channels on the output side into a single mono RCA plug. Subwoofers with 2 (stereo) RCA jack inputs will need a standard stereo male-male RCA cable.

How to connect a subwoofer to a car stereo?

Disconnect the speaker from in-built car speaker by doing mounting dock and gaining access on the rear panel of the car stereo by using wiring. After that, take out the stereo wiring and reconnect it again by using an adapter. This adapter provides power outlets to the single cable and mounts the sub in a preferable location.

How do I hook up a remote to a car stereo?

If no aftermarket car stereo is installed, it will be slightly harder. In that case you have a few options: Run the remote wire to a +12V wire switched on with the ignition or the accessory position of the ignition switch (this is the 1st choice)

How to connect a subwoofer to an RCA receiver?

Make a connection between the LFE jack which is found on the receiver and the output port of the subwoofer’s box. This will differ from one make of the subwoofer to the other. Most models of subwoofers have this jack as the only connector of the RCA found on both terminals of the gadget.

Can you wire rear speaker output as subwoofer output?

You can use extra battery rather than factory stock to induce more power to the car. By wiring rear speaker output as a subwoofer output, you will not get a shattering bass, but it will add extra frequency to your sound system. You can also make a plan to use the subwoofer as a boat anchor and a doorstop on the floor or the door panel.

Related posts: