Light bar hook up

light bar hook up

How to connect a light bar to a battery?

Connect the light bar’s red wire to the positive side of the battery or power supply and the black wire to the negative terminal. If the light does not work, you need to take care of this problem before continuing with the installation.

How to wire a relay for LED light bar?

In order to wire a relay for the LED light bar, you’ll need a battery, a switch, and of course a relay. After arranging all these components, follow the below mentioned step-by-step guide. First of all, connect the outlet or pin number 30 on your relay to the positive terminal of the battery.

What tools do I need to install light bar wiring?

Vise-locks or C-clamps can hold the light bar in position when marking holes. For light bar wiring, you need a pair of wire cutters, wire strippers and the correct crimpers for the connectors you choose.

How hard is it to install an LED light bar?

As long as you follow instructions and have basic tools, you can install your new LED light bar with little difficulty. This article provides basic installation guidance to supplement the directions or schematics that came with your light bar.

How do I wire my LED light bar to my battery?

A more complete guide to LED light bar wiring is here, but the general steps are these: Always disconnect the negative terminal of your battery before starting the wiring. Use automotive grade wire. GPT is acceptable, but GTX and TLX grades are better. Use a wire gauge that matches or exceeds the maximum current of your LED light bar.

Can you wire an LED light bar without a relay?

This is a guide on how to wire an LED light bar without a relay. If you are wiring an LED light bar/off-road light from scratch you may want to avoid the hassle of connecting a relay as well when you install it.

What size wire do I need to power a light bar?

Use a wire gauge that matches or exceeds the maximum current of your LED light bar. Fuse power wires to the expected current draw, not the wire size. Use an automotive switching relay if the light bar draws 10A or greater. With or without a relay, use a cab switch rated for at least 10 amps.

Which side of the battery do you connect the led to?

Always connect the longest leg to the positive terminal of the battery and the shortest leg to the negative terminal. Else the LED wont light or could be damaged. Do not use a battery with a voltage over 3V, else your LED might explode.

How to install LED light bar mount?

How to Install LED Light Bar Mounts 1 Stud Mounting. Smaller light bars are often mounted within the vehicle grill or under the bumper in the case of fog lamps. 2 End Brackets. ... 3 Channel Brackets. ... 4 LED Lights Mounting Bars. ... 5 Original Equipment Brackets. ...

How do I know if my light bar is bad?

Tip: When testing the light bar, do not look directly into the LEDs as the high-intensity light can damage your eyes. Depending on the size or manufacturer of your LED light bar, mounting brackets differ. Smaller light bars, around 4 to 12 inches, may have one or more threaded studs at the housing bottom.

What do you need to wire a light bar?

For light bar wiring, you need a pair of wire cutters, wire strippers and the correct crimpers for the connectors you choose. Use marine grade or IP-rated connectors and you can forgo tape and caulking to seal splices.

How to install end brackets for light bars?

To position end brackets properly, attach them to the housing’s end studs and – with help from one or two assistants – place the light bar in its final position. With free hands, you can make accurate marks through the holes of the bracket bases for drilling. Tip: Use three drill bit sizes to make a single hole.

Related posts: